Is this your business? Receive leads and respond to reviews. Claiming is easy and free. Claim this business

Semi-tek Systems Inc

Toronto ON M3H 2M4
Write a Review
Write a Review
Semi-tek Systems Inc
Star Score
StarScore uses a complex algorithm which considers a company’s review ratings, responsiveness, reputation, and recency. Learn more.


This is the average rating based on homeowner reviews.
This indicates how long it's been since the last review.
Low reputation means there has been review tampering or a company request to remove a review. This score is also impacted when we do not have enough information i.e: low number of reviews.
How well a company responds to Service Requests and Reviews.
Reviews by rating (past 12 months)

Review for Semi-tek Systems Inc

Average customer rating:
0 10 (1 reviews)

Sort by

Peter Lee in Toronto
Peter Lee in Toronto
9 reviews Toronto, ON

Range hood installation

We were looking to install an island range hood in our kitchen. Noel Samson, the owner of Semi-tek met with us and told us that he could help. The job involved the installation of the range hood with 6" round ductwork, across 6' between ceiling joist and vent to the exterior brick wall. The work turned out to be a complete disaster - i.e. it would make for an ideal episode for Holmes on Homes. When Noel left, the dimmer switch on the wall and the electrical circuit in our bedroom was dead. The ducting was shoddy - at the bottom of the elbow duct, the elbow was clearly dented at the lip. With the range hood on, air would be exhausted between the joists. The 6' length of duct was held up by half-stripped electrical wire, screwed into the joists. The hole in the exterior wall was crudely drilled, leaving brick fragments on our garden hose below. The exterior vent was not even properly installed. 2" of spray foam was used as an adhesive and the vent was "stuck" on the foam. I took apart the range hood because I couldn't trust the installation. Found loose screws between the canopy and the flue. The angle mounting brackets were installed with half the fasteners required. Each bracket was mounted on to one instead of the two required mounting locations. Four extension brackets were missing. Only one set of brackets was mounted on the top holes of the range hood. All the non-ducted parts were also missing. It's fine that we don't need them, but the least he could have done was to ask us for permission to take them. All debris and garbage that wasn't left just laying around was stuffed into the range hood box. No debris was cleared. Absolutely outrageous - I'm not sure how he could be in business. If he didn't know what he was doing, he should have told us. Even his electrical work is suspect.

Was this review helpful?
The reviews on this page are the subjective opinion of the Author and not of HomeStars Inc.

Is this your business?

Receive leads and respond to reviews.
Claiming is easy and free.

Claim this business
Company profile information is not moderated by HomeStars. Ask the contractor to verify before hiring.
Looking for Electricians pros in Toronto?